ASTM B(). Standard Specification for Nickel Plate, Sheet, and Strip. standard by ASTM International, 10/01/ View all product details. Manufacturer & suppliers of Nickel / ASTM B Plate Aesteiron Steels leading Nickel / ASTM B Plate manufacturers, founded in Buy ASTM B() Standard Specification for Nickel Plate, Sheet, and Strip from SAI Global.
|Published (Last):||22 September 2014|
|PDF File Size:||12.66 Mb|
|ePub File Size:||4.58 Mb|
|Price:||Free* [*Free Regsitration Required]|
Historical Version s – view previous versions of standard.
ASTM B – 93ae1 Standard Specification for Nickel Plate, Sheet, and Strip
The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
Sheet metal parts are characterized by high strength, good dimensional tolerances, good surface finish, and relatively low cost. Offer on Fasteners Sitemap. Sheet and Strip can be cold rolled to higher strength.
Test methods chemical analysis, mechanical test, grain aastm test shall be performed in accordance to referenced ASTM documents itemized herein.
AlloyAlloy Brand: These sheets are made by rolling process. The material shall be uniform in quality and temper, smooth, commercially straight or flat, and free of injurious imperfections. The material shall conform to the mechanical property requirements for tensile strength, yield strength, elongation, and Rockwell hardness.
Also Each flat rolled product owes its final properties not just in the rolling process itself but to its vital interactions with the preparatory steps of alloying, casting, scalping asgm pre-heating; intermediate annealing; and such later finishing steps as a solution heat treatment or final annealing, stretching, leveling, slitting, edge trimming and aging.
In plate products, this can be achieved by controlling the finishing temperature in h162 rolling and the elimination of the anneal that follows hot rolling.
It is informational only and not an official part of the standard; astn full text of the standard itself must be referred to for its use and application. Cutting is used to separate large sheets into smaller pieces, to cut out a part perimeter, or to make holes cavities in a part.
ASTM B162 Alloy 200 / 201 Strip Plate and Sheet Suppliers
Deep drawing is a manufacturing process that is used extensively in the forming of sheet metal under tensile and compressive conditions, without atsm the sheet thickness. Looking for some more information? Siddhagiri Metals and Tubes Manufacturer: Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.
For deep drawing and spinning quality sheet and strip, the material shall conform to specified values for grain size and hardness properties. This abstract is a brief summary of the referenced standard.
Link to Satm This link will always route to the current Active version of the standard. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.
The material shall conform to the chemical requirements for nickel, copper, iron, manganese, carbon, silicon, and sulfur.
Siddhagiri Metals and Tubes Rating: